enrico roccus
Altre idee da enrico
My homemade press brake, had it bending 10mm plate 40mm wide no problem so far. Going to make a bigger one when I've got more than a spare morning

My homemade press brake, had it bending 10mm plate 40mm wide no problem so far. Going to make a bigger one when I've got more than a spare morning

Crater Maker Dimple Die 4140 hardened steel

Crater Maker Dimple Die 4140 hardened steel

Need to add a little bit of detail to your work?  Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel.  These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish.  Dimensions are 1.5" diameter by approximately 1" combined height.   Each one of these dies have been tested on 22, 20, and 18ga mild steel…

Need to add a little bit of detail to your work? Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel. These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish. Dimensions are 1.5" diameter by approximately 1" combined height. Each one of these dies have been tested on 22, 20, and 18ga mild steel…

Embossing tutorial & video

Embossing tutorial & video

Teflon tools for Metal Embossing. via Etsy

Teflon tools for Metal Embossing. via Etsy

Dimple Dies are Heat Treated and Will Work Panels up to 0.1875". These Dies Are Used To Flare or Flange an Existing Hole In Sheet Metal. Dimpled Sheet Metal Becomes Stronger, More Rigid and Lighter Weight. And it Creates a Custom Appearance.

Dimple Dies are Heat Treated and Will Work Panels up to 0.1875". These Dies Are Used To Flare or Flange an Existing Hole In Sheet Metal. Dimpled Sheet Metal Becomes Stronger, More Rigid and Lighter Weight. And it Creates a Custom Appearance.

Exceptionally useful sheet metal benders which fit to the jaws of a vice with magnets. The die is in three parts allowing a range of complex bends to be formed. Available in two sizes, 100mm or 150mm.

Exceptionally useful sheet metal benders which fit to the jaws of a vice with magnets. The die is in three parts allowing a range of complex bends to be formed. Available in two sizes, 100mm or 150mm.

Ron Covell Rounding Over Dies for putting a radiused edge on sheet metal.  Works on Pexto 622 rotary machines and others

Ron Covell Rounding Over Dies for putting a radiused edge on sheet metal. Works on Pexto 622 rotary machines and others

Irvan-Smith, Inc. : Metal Ace F240 English Wheel Anvil - 24" Radius 3X3 [EGW-F240] - $108.00

Irvan-Smith, Inc. : Metal Ace F240 English Wheel Anvil - 24" Radius 3X3 [EGW-F240] - $108.00

mig welding technique

mig welding technique